Thermo Scientific APEX 100 User Manual page 328

8) Press the Go button and the "Modbus TCP/IP Configuration" screen appears.
In most instances, the IP, subnet-mask, gateway, and MAC addresses are set
automatically by the network and the appropriate addresses will be shown in the
detector's display panel. (In the example below, we have entered all zeros in this
screen, so we can show you how to change the communication parameters—except
the MAC address, which cannot be edited.)
Modbus TCP/IP Configuration
Here is a list of the communications parameters found in this menu. Please note that all
parameters are editable, except the MAC address.
Parameters
DHCP
IP
SN
GW
MAC
Page 328
Description
Dynamic host-control
protocol
IP address
Subnet-mask address
Gateway address
MAC address
Editable?
Yes—you can set DHCP to either "on"
or "off." On is the default setting.
Yes
Yes
Yes
No
Thermo Scientific APEX User's Guide