3) Navigate to the AuditCheck function and make sure it is highlighted.
AuditCheck
4) Press the Go button and page 1 of the AuditCheck menu appears.
AuditCheck – Calibrate test samples
Performing an AuditCheck Test
To perform an AuditCheck test, do the following.
1) Make sure the conveyor is running and that product is passing normally through the
search head.
2) Navigate to the test-1 function.
Peak & Phase Angle – test 1
3) Press the Go button and, if the photo-registration function is disabled, the shuttle will
fire immediately. However, if the photo-registration function is enabled, the shuttle
will wait until the next package enters the search head, then fire.
Thermo Scientific APEX User's Guide
Page 207