Changing DHCP to "On"
To change the DHCP setting to "on," do the following. Please note that, if changes have
been made to the IP, subnet-mask, or gateway address, both screens (shown below)
may display a flashing asterisk next to the DHCP function.)
1) Make sure the DHCP function is highlighted.
Dynamic Host Control Protocol
2) Press the Go button. The X changes to a check mark, indicating that DHCP is now
"on" and the network will configure the IP, subnet-mask, and gateway addresses.
Dynamic Host Control Protocol
3) Press the Back button to exit the function.
Page 334
Thermo Scientific APEX User's Guide