Manually Changing Communication Parameters; Changing The Ip Address - Thermo Scientific APEX 100 User Manual

2) Press the Go button. The check mark changes to an X, indicating that DHCP is now
"off." (The flashing asterisk tells you the DHCP setting has been modified.)
Dynamic Host Control Protocol
3) Press the Back button to exit the function.

Manually Changing Communication Parameters

If you wish to manually change the IP, subnet-mask, and gateway addresses, please
note the following.
• The DHCP setting must be set to "off."
• For your changes to take effect, you must save your settings.
How to change the IP, subnet-mask, and gateway addresses as well as save your TCP/IP
settings, is described in the following sections.

Changing the IP Address

In order to change the IP address, DHCP must be set to "off."
1) Make sure the IP address function is highlighted.
IP Address
(continued...)
Page 330 Thermo Scientific APEX User's Guide