Setting The Configuration Switches; Pin Assignments For The Ethernet (Rj45) Connector - Thermo Scientific APEX 100 User Manual

Setting the Configuration Switches

All switches should be set to the zero or "off" position, which allows you to configure all
of the card's communications parameters, except the MAC address, using the APEX
software.

Pin Assignments for the Ethernet (RJ45) Connector

Here are the pin assignments for the Ethernet (RJ45) connector.
Pin Signal
1 TD+
2 TD–
3 RD+
4
5
6 RD–
7
8
(Front view)
Thermo Scientific APEX User's Guide
Notes
Normally left unused. To insure signal integrity, these pins are tied
together and terminated to the PE via a filter circuit in the module.
Normally left unused. To insure signal integrity, these pins are tied
together and terminated to the PE via a filter circuit in the module.
Page 343