Configuring External Dhcp Settings For E2T - Mitel 3300 Technician's Handbook

Table 54: Debug Cable E2T VxWorks Settings (continued)
Prompt
startup script (s)
other (o)

Configuring External DHCP Settings for E2T

Note:This procedure applies to all controllers except the MXe/MXe Server.
You must reserve an IP address for the E2T on the DHCP server; assign
options 66 and 67 on the external DHCP (Windows NT) to E2T reserved IP
address. During installation of the 3300 ICP you will manually enter a static
IP address on the RTC card. The E2T card will send a DHCP broadcast to
obtain an IP address from the DHCP server. The DHCP server (internal or
external) must be enabled to supply a free IP and option 66 and 67.
In the following procedure examples
• IP subnet for the 3300 ICP network is 10.10.18.0
• RTC (static IP) is 10.10.18.4
• E2T (reserved by DHCP scope) is 10.10.18.58.
To reserve an IP address for the E2T on the external DHCP server:
1. Highlight the Subnet 10.10.18.0 in the DHCP server DHCP Manager
- (Local) window.
2. Click Scope and select ADD Reservation.
3. Enter the IP address and MAC address of the E2T. The MAC address
is found on the MAC Address label on the rear panel of the ICP. Use
the MAC Address label that refers to "E2T MAC" "Slot 1".
4. Click Add.
To add options 66 and 67 to the E2T card IP address:
1. Highlight the Subnet 10.10.18.0 in the DHCP server DHCP Manager
- (Local) window.
2. Click Scope and select Active Leases.
3. In the Active Leases dialog box, highlight the reserved IP address
and then click Properties.
Value Note
Installation Planner
Page 2 of 2
283