Mitel 3300 Technician's Handbook page 31

latest upgrade. On an initial installation of the 3300 ICP, this field
displays "Not Installed".
MCD Version: current Mitel Communications Director software
version that was installed using the Software Installer tool. It is NOT
the software version of the MCD blade software.
Swap: reboots the call server with the currently inactive software
version. The currently active version becomes the inactive software
version after the reboot. Swap is only displayed if an Inactive version
of the 3300 ICP software is installed.
Do not enable the Swap option during this procedure.
17. Click Save. The E2T and RTC cards are updated with the new IP
addresses, subnet mask, and VLAN ID.
18. Open a communication application (for example ProCom or
Hyperterminal) on your laptop to the 3300 ICP and set the connection
parameters (see Table 2). Log in to the server console again.
Login: admin
Password: (enter the Linux admin password)
19. Select "Configure this server". Press the Tab keyboard key until "Local
Networking Parameter" is displayed.
20. Enter the IP address of the APC-MXe card that is appropriate for your
network. The Gateway IP address changes to x.x.x.1.
21. Press the Tab keyboard key until the Reboot screen appears.
22. Reboot the server.
23. Change the address of the laptop's Network Interface Card (NIC) back
to the IP address for your network. The following procedure is for
Windows 2000 or Windows XP:
- From the Windows Start menu, click Settings, click Network and
Dial-up Connections, and then click the Local Area Network of the
laptop NIC card.
- Click Properties.
- Select Internet Protocol (TCP/IP).
- Click Properties.
- Click "Use the following IP Address" option.
- Change the address of the NIC to the Network IP Address.
Initial Setup
21