3300 ICP Technician's Handbook
•
When you remove the Quad BRI Framer module from its packaging.
DO NOT move LT/NT jumpers.
•
For the T1/E1 Combo, connect the T1 line from the service provider to
the RJ45 connector on the T1/E1 combo module. See Table 23 on
page 249 for connector pinouts.
•
The Quad BRI Framer allows a 1:1 connection to a BRI Central Office
or a crossover connection to a BRI telephone. The shielded, twisted
pair ISDN cable is connected on either end with pins 3-4, and 5-6. The
straight-through cable is used for "T" interfaces to the Central Office
and the crossover (with 3-4 and 5-6 crossed at one end) for "S"
interfaces to sets.
Quad CIM MMC
•
Support for the Quad CIM requires that the 3300 ICP is running
software Release 7.1 or later.
•
The Quad CIM MMC cannot be installed in an MXe Server.
•
The AX, CX, CXi, CX II, and CXi II can accept one Quad CIM MMC.
•
All other controllers can accept two Quad CIM MMCs.
•
When the Quad CIM MMC is used in a CX, CXi, CX II, or CXi II, only
the first three ports are operational.
172