Mitel 3300 Technician's Handbook page 218

3300 ICP Technician's Handbook
5. Reconnect the data cable and power cable to the hard disk drive. The
cables are keyed for proper connection.
6. Replace the controller cover.
7. Remount the controller.
8. Restore the connections to the Maintenance PC.
9. Manually install the software on the hard disk drive (see "Install
System Software Manually" on page 85).
10. Reconnect the controller to the network.
11. If you backed up your database in Step 1, restore the database (see
"Restore a Database" on page 132).
LX
To replace the hard drive in the LX controller:
1. If possible, back up your database (or locate the most recent backup).
2. Place the controller on the work area with the bottom facing up.
3. Remove the hard drive backing plate from the controller by removing
the six (6) small border screws (the four large screws secure the hard
drive to the backing plate). Keep the screws.
4. Unplug the ribbon cable and the power cable from the old hard drive.
5. Connect the ribbon cable and power cable to the new hard drive.
Figure 74: LX Controller Hard Drive Installation
208