Mitel 3300 Technician's Handbook page 200

3300 ICP Technician's Handbook
4. To seat the connectors, grasp the APC Module with your index finger
and thumb and press down firmly on edges. You should feel the
connectors seat together.
Tip: To ensure that the APC-CX(i) module is seated securely, press down on
it over each of the four connectors, one at a time. Once the APC is properly
installed, its four corners will rest against the standoffs located at each corner
of the APC.
5. Prepare the heat spreader for installation by removing the blue plastic
protective strips from the adhesive heat pads (see Figure 56).
Note: When you remove the blue plastic protective strips use a quick lifting
motion instead of peeling the strip off the heat pad.
Figure 56: Removing Protective Strips from Heat Pads
6. Place the four screws (supplied) in the heat spreader, and lower the
heat spreader onto the APC as shown in Figure 57. Align the cutout on
the heat spreader above the memory modules on the APC.
190