Installing Msl Software On Apc (Cx/Cxi) Or Apc-Cx(I) Ii (Cx Ii/Cxi Ii); Installing Msl Software On Apc (Cx/Cxi) Or Apc-Cx(I) - Mitel 3300 Technician's Handbook

Installing MSL Software on APC (CX/CXi) or
APC-CX(i) II
Use this procedure to install Mitel Standard Linux (MSL) software on a
replacement Application Processor Card (APC-CX(i)) or APC-CX(i) II
assembly hard drive. When you purchase the APC-CX(i) or APC-CX(i) II
with its hard drive, the (MSL) software is already installed on the hard
drive.
Refer to pages 192 and 199 and for instructions to install the replacement
hard drive.
To install the MSL software on an APC (CX/CXi):
1. Insert the MSL software CD into a portable CD-ROM drive attached to
a USB connector located on the front panel of the 3300 ICP.
2. Power down the 3300 ICP controller (page 129).
3. Power up the 3300 ICP controller.
4. Launch the secure telnet client.
- Enter open <RTC IP address> using port <2005> (command with
example IP address, open 192.168.1.2 2005).
- Enter the 3300 username and password.
5. Follow the on-screen instructions to configure the MSL. Refer to the
"Mitel Standard Linux Installation and Administration Guide" on Edocs
(http://edocs.mitel.com).
To install the MSL software on an APC-CX(i) II (CX II/CXi II):
1. Insert the MSL software CD into a portable USB CD-ROM drive
attached to a USB connector on the APC-CX(i) II assembly (at the rear
of the controller, next to the VGA connector).
2. Connect a serial cable to the RS-232 port on the APC-CX(i) II
assembly.
3. Launch a serial terminal emulator such as HyperTerminal or
NetTERM. Configure it for 38400bps, 8 bits, no parity, 1 stop bit (8n1).
4. Power down the 3300 ICP controller; see page 129.
5. Power up the 3300 ICP controller.
6. Follow the on-screen instructions on the serial terminal to install and
configure MSL. Refer to the "Mitel Standard Linux Installation and
Administration Guide" on Edocs (http://edocs.mitel.com).
(CX II/CXi II)
Software Installation
105