Controller Configuration Settings (Rtc) - Mitel 3300 Technician's Handbook

• Data VLAN (CXi - Release 9.0 and later and CXi II)
- The CXi/CXi II switch can be assigned a data VLAN to override the
default VLAN 1. By default, all ports on the CXi/CXi II switch belong
to VLAN 1.
- In addition, VLAN membership can be assigned on a per port
basis. Each port can be assigned as tagged or untagged on the
data VLAN as well as the Voice VLAN. The default is tagged.
Installation
The traditional installation remains the same as for the MX and LX
controllers because the AX, CXi, CXi II, and MXe rely on external routers
to perform VLAN routing just as the CX, CX II, MX, and LX do.
An externally managed L2 switch connected to the AX/CXi/CXi II/MXe
uplink port(s) must tag Voice VLAN traffic. This is unlike the setup for the
other controllers that do not have this requirement.

Controller Configuration Settings (RTC)

Do not change these settings unless you are directed to make changes by
an RN. Unauthorized changes may prevent the system from booting up.
Table 49: Controller Configuration Settings
Prompt
boot device
processor number
host name
file name
inet on ethernet
(e)
inet on backplane
(b)
Value
ata=0, 0
0
bootHost
ALL platforms, after Rel 8.0:
/partition1/RTC8260 or
/partition4/RTC8260
ALL platforms, Rel 6.x and 7.x:
/partition1/RTC8260
default IP address:
192.168.1.2:ffffff00
Installation Planner
Note
Boot device is Disk.
Not used.
Boot location and file name.
File names are case-sensitive.
IP address and subnet mask
(hex) for controller RTC.
Provided by your IT
administrator.
Page 1 of 2
275