Upgrade The 3300 Icp Software On The Mxe Server; Upgrading/Installing With Maximum Elements Change - Mitel 3300 Technician's Handbook

3300 ICP Technician's Handbook
- Navigate to the Application Group Licensing form on one of the
MCDs in the Application Group and make it the DLM. Then, enter
the GARID, and click Save.
5. From the DLM, navigate to the Network Elements form, see all the
Network Elements in the Application Group should, the press Sync.
Upgrade the 3300 ICP Software on the MXe
Server
Upgrading the 3300 ICP software on the MXe Server sometimes also
requires upgrading MSL—for example, when upgrading to 3300 ICP,
Release 9.0. To find out whether you need to upgrade MSL, check the RN
for the 3300 ICP software you are installing.
1. Back up the 3300 ICP database to the Installer PC.
2. Upgrade MSL using the MCD installation CD (see the "Mitel Standard
Linux Installation and Administration Guide" at http://edocs.mitel.com
for detailed instructions).
3. Use the Software Installer to upgrade the 3300 ICP software.
Note: Upgrading from from 9.0 UR1 or earlier requires powering the
controller off and on after the upgrade.
Upgrading/Installing with Maximum Elements
Change
The following options impact the upgrade/install procedure.
To upgrade and change to a default dimension:
• 30/60 maximum elements per cluster (with default or flexed
dimensions) to 250/999 maximum elements (with default dimensions)
• 250/999 maximum elements per cluster (with default dimensions) to
30/60 maximum elements per cluster (with default dimensions)
1. Back up the database (page 130).
2. Follow the standard full install procedure (page 91) using the Software
Installer.
- In the License and Options Selection form change Maximum
Elements per Cluster to or from 250. The Software Installer will
reboot the controller.
108