Configure System Ip Address (Mxe Server); Configure The Layer 2 Switch (Ax, Mxe, Cxi, Cxi Ii) - Mitel 3300 Technician's Handbook

3300 ICP Technician's Handbook

Configure System IP Address (MXe Server)

To replace the default System IP address with a new IP address:
Tip: All of the MXe Server IP addresses must be on the same subnet.
1. Launch the MSL server console, and select Configure this Server.
2. Set the APC IP address to 192.168.1.8.
Note:You must temporarily set the APC IP address to the default setting
to be able to configure system IP addresses. Once you are done
configuring these IP addresses, you will reset the IP address on the APC.
3. Disconnect the MXe Server from the network.
4. Configure a local PC with a static IP address on subnet 192.168.1.0/24
and connect it to the MXe Server. See Table 1 on page 15 for the list
of addresses that will be used by the MXe Server.
5. Launch the web-based MSL Server-Manager, and select the Mitel
Communications Director blade panel. The APC IP address will be
read-only. This panel now allows you to configure system IP
addresses, RTC, E2T, L2 IP, and Gateway IP. These IP addresses
must be on the customer subnet. When you are finished configuring
the IP addresses, click Save.
6. In the MSL server console menu, select Configure this Server, and
reset the APC IP address to the customer subnet (same subnet as the
above IP addresses).
7. Click Activate Changes (this will cause a system reset).

Configure the Layer 2 Switch (AX, MXe, CXi, CXi II)

The internal Layer 2 switch in the CXi, CXi II, and MXe must be
programmed with an IP address in the same subnet as the RTC IP
address, or the switch will not operate properly.
To set the Layer 2 switch IP address, complete the System IP Properties
form, and then reboot the system.
Note:The 16 10/100 Mbps ports are disabled on the CXi and CXi II during
bootup, as is the right-hand side (when viewed from the front) Gigabit port
on the CX, CX II and MXe.
26