Mitel 3300 Technician's Handbook page 30

3300 ICP Technician's Handbook
14. Click Next. After you click Next, you should see a message stating
that the addresses were successfully modified displayed in green text.
The system automatically reserves four IP addresses that are required
to support the system in the network. These addresses must be valid,
contiguous, and available in the network.
.
15. Enter three, valid, available, and contiguous IP addresses for the
- Media Gateway IP (IP address of the Real Time Controller card)
- E2T Card IP
- Layer 2 (L2) IP
16. Enter the Voice VLAN ID (1 to 4093), if required for the network.
At the bottom of the Mitel Communications Director screen, the
following information is displayed:
Active 3300 ICP Version: currently active system software version
Inactive 3300 ICP Version: previous system software version before
20
Figure 4: Enter the New Addresses