Apc-Cx(I) Ii Assembly - Mitel 3300 Technician's Handbook

3300 ICP Technician's Handbook

APC-CX(i) II Assembly

The APC-CX(i) II Assembly is an embedded PC with support for USB,
VGA, RS-232,10/100/1000-base-T Ethernet and SATA hard disk drives
that can be installed in the CX II/CXi II. This section provides instructions
on how to
• install an APC-CX(i) II Assembly
• replace the APC-CX(i) II hard disk drive
• replace the APC-CX(i) II battery.
Tip: Although the battery has an operational life of 5-7 years, should
APC-CX(i) II
errors, first change the battery. Then, If the symptoms persist, replace the
APC-CX(i) II Assembly
The APC-CX(i) II Assembly is shipped mounted on a carrier board with a
factory-installed hard disk drive. Figure 60 (page 194) shows the contents
of the kit. (The hard disk drive is mounted on the underside of the
APC-CX(i) II Assembly and not visible.) Confirm that all parts are present
before proceeding with installation.
APC-CX(i) II
Figure 60: APC-CX(i) II Assembly Kit Components
194
develop symptoms of time and date loss and CMOS memory
.
Ethernet
Cable
Housekeeping
Cable
SATA Data
Cable
Retaining Screws
the