Setting Your Dns Server Ip; Verify The Connections - Mitel 3300 Technician's Handbook

3300 ICP Technician's Handbook

Setting your DNS Server IP

1. Log in to the MXe-Server System Administration Tool (for example
10.x.y.25).
2. Navigate to the System IP Properties form.
3. On the lower panel, enter your corporate DNS Server IP address in the
DNS Server IP address field.
4. Click Save.
Note:All of the IP addresses will be read-only in the System Administration
Tool.

Verify the Connections

Perform the steps below to verify the connections between the
Maintenance PC and the controller.
1. To verify the serial connection in the VT100 emulator, press ENTER.
- If the serial connection is installed and programmed properly, a
right-pointing arrow () is displayed when you press ENTER.
2. To verify the Ethernet connection from the PC:
- For the MXE Server: PING the controller System IP address
(default is 192.168.1.5).
- For all other controllers: PING the controller RTC IP address
(default is 192.168.1.2).
- If the connection is installed and programmed correctly, the
controller replies to the PING.
24