Mitel 3300 Technician's Handbook page 153

Viewing and modifying the static IP address:
1. Access the Configuration (Debug) Menu on the IP Phone. Refer to the
3300 ICP Troubleshooting Guide for instructions.
2. At NETWORK PARAMETERS?, press Yes. VIEW CURRENT
VALUES? appears.
3. Do one of the following:
- Press Yes, and then press the Up/Down volume keys to view each
setting. When you return to VIEW CURRENT VALUES?, press No.
VIEW STATIC VALUES? appears.
- Press No. VIEW STATIC VALUES? appears.
4. Do one of the following:
- Press Yes, and then press the Up/Down volume keys to view each
setting. When you return to VIEW STATIC VALUES?, press No.
MODIFY STATIC VALUES? appears.
- Press No. MODIFY STATIC VALUES? appears.
5. Do one of the following and then reboot the phone:
- Press Yes, and then press the Up/Down volume keys to scroll
through each setting. Use the keypad to modify the Phone IP
address (static), and then follow the prompts to store the changes
and reboot the phone.
- To reset the factory defaults, press Default, and then follow the
prompts to set and store the factory defaults and reboot the phone.
6. To exit the current menu without a reboot:
- To return to the main menu, press Yes at EXIT MENU?
- To return to the default display, press Superkey.
Setting Static IP Addresses on Non-Dual Mode Sets
To set static IP address on the IP telephones:
1. Plug the set cable and power into the set while holding down the
Volume Up key for 3 seconds to display Set Static IP (Yes #/No *).
2. At the STATIC IP SETUP MODE.
- Use the Volume Up/Down keys to navigate
- Use the * key to back up (to correct an error)
- Use the # key to insert a decimal and move to the next field.
Maintenance
143