Mitel 3300 Technician's Handbook page 234

3300 ICP Technician's Handbook
Figure 79: Position the RAID Controller Board
7. Slowly retract the RAID controller from the LED module holes until its
high-density HDD connector is aligned over the backplane connector.
8. Press the high-density HDD backplane connector gently into place on
the backplane connector.
9. Secure the RAID controller to the standoffs with the three (3) screws.
10. Take the pre-formed IDE interconnect cable that was shipped with the
2-pack hard drives and connect the host connector (blue) to the RTC
(host) IDE connector on the underside of the MXe carrier board (MXe
II), or to the IDE connector on the mid-plane (MXe Server). Note that
the connector is keyed.
11. Route the pre-formed IDE cable through the channel in the cabinet
chassis and connect the other end to the keyed HDD interface
connector on the RAID controller.
CAUTION: Ensure that you route the IDE interconnect cable
through the channel in the cabinet chassis (see Figure 80).
224