Mitel 3300 Technician's Handbook page 107

Table 8: Closing the SI before Upgrade is complete (continued)
Software Installer
is closed...
... during the
License
Configuration
... during the internal
Restore
... during the
activation of the new
load (Swap and
system reset)
Resume an Online Upgrade
1. Launch the Software Installer.
2. Login and connect to the 3300. If the SI determines that an upgrade is
in progress on the 3300, it will display the In Progress screen.
3. Click on Resume Upgrade.
CAUTION: If you have scheduled an immediate Software
Activation, your controller will automatically reboot when
the upgrade is complete.
Tip: If you click on Cancel instead, the upgrade will stop and the status file
will be removed from the controller. You will start from the beginning again
the next time you launch the Software Installer.
Complete Online Upgrade – Software Activation
Activate the new software when traffic is lowest, and the reboot will have
the minimum impact. Reconnect the controller to the Software Installer.
Click Start Software Activation.
After the upgrade, follow the instructions in "Reprogram external DHCP
servers (required for Release 7.0)" on page 100 to reprogram the DHCP
server(s) to use the new DHCP options.
What happens to the upgrade in progress?
The 3300 already has all the information it needs to
continue.
The upgrade will finish.
The 3300 will control the internal restore and all
subsequent steps.
The upgrade will finish.
The 3300 has all the information it needs to complete the
upgrade process.
The upgrade will finish.
Software Installation
Page 2 of 2
97