Apply A Software Patch - Mitel 3300 Technician's Handbook

12. After the installation is complete, log into the System Administration
Tool.
13. In the Dimension Selection form, change dimensions to match the
quantities in the form that you printed in step 1 and click Save.
14. Reboot the system.
15. Launch the System Administration tool.
16. In the Restore form, select Use current Dimension Selections
(select if Dimensions were modified).
17. Click Start Restore.
18. Reboot the system.
19. Back up the database.

Apply a Software Patch

Use the Software Installer to apply a software patch, from Release 4.1 and
later. Get the patch (service pack) from Mitel OnLine or from Technical
Support.
Tip: Always follow the steps in the readme.txt file for the most up-to-date
installation instructions.They take precedence over the following instructions.
Note: You can automate the process of downloading, installing, and
activating software (including patches) by programming scheduled events in
the System Administration Tool. For details, refer to "Software Events" in the
3300 System Administration Tool Help.
Time: This process takes approximately 15 to 30 minutes including reboot.
To apply a software patch with the Software Installer:
1. Copy the service pack software to a directory that is accessible to the
Software Installer.
2. Launch the Software Installer.
3. Choose 3300 ICP or MXe Server and click Next.
4. In the SI Login Screen, log in and complete the IP addresses. Click
Configure.
5. Navigate to the location of the service pack software, select it, and
select Apply Patch.
Software Installation
111