Mitel 3300 Technician's Handbook page 64

3300 ICP Technician's Handbook
CX/CXi
1. Peel off the rubber bumper from one of the brackets. Removing the
rubber bumper makes it easier to insert the controller into the rack.
2. Turn the cabinet over and place the bracket on the left side of the
cabinet as shown in Figure 17. The farther you position the bracket
back from the front of the cabinet, the farther the cabinet will protrude
from the rack.
3. Place the plate over the bracket.
4. Insert the standoffs on the plate into the holes in the side of the bracket.
Ensure that at least two of the standoffs are in holes on the bracket.
5. Fasten the plate securely to the cabinet with the two screws. Ensure
that the bracket is locked into place.
6. Install the second bracket on the left side of the rack.
7. Turn the controller upright and slide into the rack.
8. Fasten the right bracket to the rack.
Figure 17: CX/CXi Controller Rack-Mount Bracket Installation
54