Mitel 3300 Technician's Handbook page 237

4. Position the new RAID controller board by carefully inserting the LED
indicators into the holes in the controller rear panel (see Figure 81).
Figure 81: Position the SATA RAID Controller Board
5. Slowly retract the RAID controller from the LED holes until the
mounting holes align with the standoffs.
6. Secure the RAID controller to the standoffs with the three (3) screws.
7. Cut the cable tie joining the I2C (small ribbon) cable to the SATA cable.
8. Connect the I2C (small ribbon) cable to the P5 RAID I2C connector on
the RAID controller.
9. Disconnect the SATA cable from the HD1 connector on the HD
backplane and reconnect it to the Host P1 connector on the RAID
controller.
10. Using one of the supplied SATA cables, connect the HD1 connector
on the HD backplane to the HD1 P3 connector on the RAID controller.
11. Using the second SATA cable, connect the HD2 connector on the HD
backplane to the HD2 P2 connector on the RAID controller.
Install and Replace Units
RAID CONTROLLER
RAID CONTROLLER LEDs
REAR PANEL
227