3300 ICP Technician's Handbook
6. Replace the controller card and connect the cables.
7. Plug in and turn on the power supplies and power up the controller.
8. Perform a full install of the system software from the Software Installer
tool.
To upgrade Flash 1 to add voice mail capability:
1. Power down the controller.
2. Turn off both power switches on the power supplies.
3. Remove the controller card (page 232).
4. Slide out Flash 1, and slide the 4 GByte Voice Mail Flash into the
Flash 1 position.
5. Replace the controller card and connect the cables.
6. Plug in and turn on the power supplies and power up the controller.
7. Perform a full install of the system software from the MCD Software
Installer tool.
Note: A full install formats the
partitions. It is required if the system software was initially installed with a
512MB Flash 1 card present.
234
4 GByte
flash and creates the voice mail