Mitel 3300 Technician's Handbook page 226

3300 ICP Technician's Handbook
7. Tighten the thumb screw.
8. The rebuild process starts automatically. Mirroring is indicated by the
HD LEDs. The source drive LED flashes quickly (indicating that the
disk is being accessed) while the destination drive flashes slowly. The
rebuild is complete when the destination drive LED no longer flashes
slowly (approximately 80G per hour).
Replace Both Hard Drives in an MXe III
Replace both hard drives if they are both defective, or if the system is still
under warranty.
Note: Contact Mitel Repair Services before proceeding with warranty work.
CAUTION: You must install only the first hard drive before
you boot the system. After the system is fully booted, slide
the second hard drive into the HD2 position.
To replace both hard drives in an MXe III:
1. Ensure that you have a database backup, if possible.
2. Loosen the captive screws and slide the hard drives from the hard
drive carrier.
3. Clear the sockets (refer to Knowledge Base Article 06-2806-00012 for
steps that are unqiue to MXe III).
4. Replace the old hard drive with the new hard drive in the hard drive
carrier and secure with the four screws. Make sure it is correctly
oriented (right side up); see Figure 75.
5. Slide the first hard drive into the HD1 position. DO NOT INSTALL the
second hard drive at this time.
6. Push to seat the first hard drive into the hard drive backplane.
7. Tighten the thumb screw.
8. Manually install the software on the hard drive (see "Install System
Software Manually" on page 85).
9. Replace the second old hard drive with the second new hard drive in
the hard drive carrier and secure with the four screws.
10. Slide the second hard drive into the HD2 position.
216