Connect Pc To Controller; Pc Requirements; Ax, Mxe, Cx, Cxi, Cx Ii And Cxi Ii Controller - Mitel 3300 Technician's Handbook

Connect PC to Controller

To configure the system, you must connect a PC to the controller.

PC Requirements

You need a Windows-based computer to program, maintain and
troubleshoot the 3300 ICP, and to install/upgrade the MCD software.
Computer Recommendations
• Windows ® NT 4.0, Windows 2000, Windows XP, or Windows Vista
Business or Ultimate.
Computer Requirements
• Windows 98, Windows NT 4.0, Windows 2000, Windows XP, or
Windows Vista.
• Network interface card (NIC)
• 1 GB free disk space (minimum)
• Internet Explorer 6.0, 7.0 or 8.0 with the latest Service Pack and
128-bit encryption. (IE 7.0 or 8.0 can be used with Rel 7.1 UR2 and
later.)
• JRE (Java Run-time Environment) 1.6.0_1 or later installed
• VT100™ emulator program
• FTP Server (can be installed with Microsoft
Tip: Windows 98 with PWS does NOT include an FTP server application
required for installations of 3300 ICP Software before Rel 8.0, and will not
work for the software installation/upgrade process unless a third-party server
application is used. If you are upgrading Rel 8.0+ software on a Rel 8.0 or
8.0+ system, you don't need an external FTP server.

AX, MXe, CX, CXi, CX II and CXi II Controller

1. Connect an RS-232 straight DTE male to female serial cable between
the controller's Maintenance port and the PC's serial port (cable not
provided).
2. Program the PC's serial port (from the communication program) with
the following settings:
- Baud Rate: 9600
- Data Bits: 8
- Parity: None
- Stop Bits: 1
- Flow Control: None
Initial Setup
®
IIS or PWS, for example)
13