Mitel 3300 Technician's Handbook page 98

3300 ICP Technician's Handbook
10. If you have an E2T card, do the following:
• Launch Internet Explorer and type the IP address of the controller (for
example, http://<RTC IP address>). Log into the 3300 ICP ESM using
the default username (system) and password (password).
Tips:
• The Installer PC must have the same subnet address as the RTC IP (for
example, 192.168.1.n) to launch ESM.
• If login fails or you experience difficulty excuting maintenace commands,
it may be because the system is not finished loading. Wait a few minutes
and try logging in again.
• If you enter an incorrect username/password three times in a row, the
system will prevent you from attempting to log in with this
username/password for a period of 15 minutes.
• Enter the UPGRADEBOOTROM E2T command.
11. Complete the installation using the System Administration Tool (see
Step 12) or the Software Installer Tool (see "Install System Software
using the Software Installer" on page 91).
12. PING the controller to verify that you have established a connection.
13. Set the options in the License and Option Selection form according
to your purchased Mitel options. Refer to your records or go to the
AMC (page 29).
Tip: Since the installation of new software erases all of your system settings,
you must complete this form even if you have not purchased any new options.
a. Access the Software Administration Tool.
a. Select View Alphabetically in the view drop-down list.
b. Click License and Option Selection. Click Change in the top left
corner.
c. Enter the information for the system options you purchased.
d. Enter your Mitel Options Password in the Password field.
e. Change the Configuration options as needed.
Tip: We recommend that you enable Networking Option and Mitai/Tapi
Computer Integration.
f. Click Save. A pop-up window instructs you to restore or reboot.
Click OK to close the window.
88