Mitel 3300 Technician's Handbook page 97

Table 7: VxWorks Settings (continued)
Prompt
inet on ethernet
(e)
inet on backplane
(b)
host inet (h)
gateway inet (g)
user (u)
ftp password (ftp)
flags (f)
target name (n)
startup script (s)
other (o)
9. At [VXWorks Boot], type @, or press the controller Reset button.
Time: The system takes approximately 30 minutes to format the hard drive
and install the software.
Value
ftp
ftp
0x0
FixPartition
Software Installation
Note
IP address and subnet mask (hex)
for controller RTC (for example,
134.199.63.11:ffffff00). Obtain it
from your IT administrator.
IP address of FTP Server. Used
for software upgrades.
IP address of the end user's
default gateway for the 3300 ICP
(must be outside the DHCP
range).
User name of FTP Server.
Password of FTP Server.
Uses host inet IP address.
Used to partition a hard drive or
AX flash card that has no system
software on it.
Note: If the hard disk comes
without software, you must use
"FixPartition" to partition the hard
disk for the install.
Note: During the installation
process, the system automatically
changes this parameter to qefcc
(CX(i) II and MXe III) or motfcc (all
other controllers).
Page 2 of 2
87