Manual License And Options Entry Via Mcd Software Installer Tool - Mitel 3300 Technician's Handbook

3300 ICP Technician's Handbook
3. Click Next to display the In Progress screen. Click Save to commit
your changes.
4. Click Start. After the reboot is complete, log into the System
Administration Tool and issue the DBMS Save maintenance
command.
5. Issue the DBMS Stat command to verify the DBMS Save and to
ensure that the DBMS_Initialized Flag is on.
Manual License and Options Entry via MCD Software
Installer Tool
Note:This procedure is not supported on the MXe Server. Refer to the
Software Installer Help for the offline licensing procedure for the MXe
Server.
1. Launch the Software Installer and select either the MXe Server check
box or the 3300 ICP check box to get to the Login screen.
2. Enter the Iogin information and the IP addresses. Click Configure.
Tip: If the SI is connecting to the MXe from behind a firewall, the firewall must
be configured to allow https (443), ftp (20, 21), and ssh (22).
Note that a DNS server is required.
3. If the software load you need is a higher release than the software
pre-loaded on the MXe Server's hard drive, or if you are installing on
a 3300 ICP, click Perform Upgrade.
If the pre-installed software on the MXe server is the latest release,
click License and Restore.
4. If you selected Perform Upgrade, type in or browse to the location of
the upgrade software.
5. Click Next to get to the License and Options Selection dialog.
6. Allocate the number of licenses in the appropriate fields.
7. Select the appropriate Country variant and Configuration Options.
8. Click Save to commit your changes to the database.
9. Reset the controller (page 129).
34