Install Mitel Application Server Software - Mitel 3300 Technician's Handbook

3300 ICP Technician's Handbook

Install Mitel Application Server Software

8. Insert the Mitel Communications Director Recovery Disk that was
shipped with the MXe Server into the external CD/DVD drive.
9. Run the CD-ROM test. It takes approximately 5 minutes to complete.
10. Reset the MXe Server by pressing the Reset button on the front panel.
After several seconds, the system BIOS appears.
11. The Mitel Application Server (MAS) operating system initializes and
the Server Console window opens. You are prompted to set the
following parameters in a series of screens. For VT100 sessions,
press the Enter or Return key to commit selections.
MAS Installation Screen
Choose Language
Type of Media
No Driver Found
Select Device Driver to Load
CD Found (Test CD Media)
If you are prompted to upgrade (replace hard
drive) or reformat
Warning - All disks will be Reformatted and
any data will be lost. Proceed?
Time Zone Selection
Formatting / file system . . . .
Package Installation . . . .
12. When prompted, remove the CD and select Reboot to reload the MAS
operating system with the new settings. The software takes
approximately 10 minutes to reload.
148
Table 20: MAS Installation Settings
Setting
Choose English
Select Local CD-ROM
Choose Select Driver
Select USB Mass Storage
Driver for Linux (usb-storage)
Select OK to test Media
Select Erase all Disks and
perform a Fresh Install
Select Yes
Select the country to set time
zone