Mitel 3300 Technician's Handbook page 106

3300 ICP Technician's Handbook
Cancel or Close an Online Upgrade
You can cancel your online upgrade at any time without affecting system
users. The upgrade is terminated either immediately or after completion of
the current step.
Table 8 lists the impact of closing the Software Installer during an upgrade.
Depending on when you close the Software Installer, you may be able to
resume where you left off by reconnecting later. See "Resume an Online
Upgrade" on page 97.
Table 8: Closing the SI before Upgrade is complete
Software Installer
is closed...
... prior to starting
Upgrade
... during software
file transfer (while
performing the ftp
push)
... while the 3300 is
extracting the
software files
... following the file
transfer
... during the internal
Backup
96
What happens to the upgrade in progress?
No record of user input will be saved. You will have to
re-enter all the options when you log in to the Software
Installer again.
During the software transfer portion of the upgrade, the
3300 will request that the 3300 send individual files to the
hard drive. When the file transfer is complete, the 3300
will begin unzipping and extracting each file.
If the SI is closed prior to completing the file transfer, the
3300 will remain in a file request state.
The upgrade will not finish because not all of the files
have been transferred to the 3300.
The extraction is not complete.
The upgrade will not finish because not all of the files
have been transferred to the 3300.
If the user has chosen the option that causes Software
Activation Immediately after the file transfer is complete
or a Software Activation time has been set, then
- The upgrade will finish.
If the user has chosen to delay the Software Activation,
but has not specified a time for it to run, then
- The upgrade will not finish.
The 3300 will control the internal backup and all
subsequent steps.
The upgrade will finish.
Page 1 of 2