Mitel 3300 Technician's Handbook page 192

3300 ICP Technician's Handbook
7. Attach the mounting plate to the standoffs and the back panel of the
controller using the supplied screws.
Figure 49: AOB Mounting Plate in Position
8. Lower the AOB on to the mounting plate and secure it with the four
smaller screws supplied with the AOB.
9. Connect the other ends of the flex cable and power cable where
indicated in Figure 50 (page
the tabs at the end of the connector to loosen it, insert the cable label
side up, and then press down on the tabs to tighten the connector.
Figure 50: Attach Flex cable and Power Cable to AOB
10. Replace the top cover and power up the controller.
11. In the System Administration Tool, go the Analog Services Units
form.
12. Select Unit 4 and click Modify.
182
182). To attach the flex cable, lift up on