Mitel 3300 Technician's Handbook page 143

CAUTION: You must reboot the controller after restoring a
database. Service will be LOST during this reboot.
You need the following information and equipment to restore a database:
 Installer PC (page 13)
 IP address of the Controller
 System Administration Tool username and password
Database Restore Procedure
Time: The system takes approximately 30 to 90 minutes to restore an
average-sized database, during which time the files are copied to the
controller. Once the files have been copied, you must reset the controller.
Note that the system can take up to an additional 1 hour to reset.
Time: Restoring an AX database may take longer than 90 minutes.
Tip: When restoring an AX database, the voice mail messages are not
restored because they are not saved when doing a backup.
1. Click Restore in the Maintenance and Diagnostics menu.
2. Copy the identitydb.obj file to your PC (required for every user profile
on every PC used for backup/restore). Follow on-screen instructions.
Tip: If you are doing the restore on the same PC the backup was saved to
and you are logged in as the same user (same user profile), you don't need
to copy the identitydb.obj again.
3. Type the location of the database that is being restored, or use the
browse facility.
4. Click Yes if you want to include Hotel/Motel wake up and room status
information in the restore.
5. Prior to Rel 5.1:Choose the Dimension Selections (page 108)
- if there are no changes to the software dimensions, accept Use
Dimension Selections from backup file
OR
- if you are using new Dimension Selection information, click Use
Current Dimension Selections.
Maintenance
133