Mitel 3300 Technician's Handbook page 27

Configure MAS Parameters
4. After the Server Console screen appears, you are prompted to accept
the End-User License Agreement. Select Accept.
5. In the configuration screens, select the following settings:
Table 3: MAS Configuration Parameters
Configuration Screen
Restore from Backup (this screen
relates to a backup of the Linux
database)
Choose Linux Admin Password
Select Primary Domain Name
Select System Name
Enter Local Networking Parameters
(local IP address for this server)
Select Local Subnet Mask (see Note
below)
Select Operating Mode
Select Gateway Address
Set DHCP Server Configuration
Corporate DNS Server Address
Application Record ID
Activate Configuration changes
Note:Use 255.255.255.0 unless your network requires a different subnet
mask. If your network requires a different Local Subnet Mask, change it now.
You can only change the subnet mask through the server console. In the
MAS Server Manager application, the subnet mask is a read-only field.
Required Setting
Select No.
Enter a password. Then, enter it again to
verify it. Note that passwords are
case-sensitive. Also, see Caution below
this table.
Enter name (for example mitel.com)
Enter name (for example the company
name)
Enter 192.168.1.8
(INITIALLY, KEEP AS DEFAULT!!!)
Enter 255.255.255.0
Select Server-only
Enter 192.168.1.1 (INITIALLY, KEEP AS
DEFAULT!!!)
Select Off - Do not provide DHCP
Service to local Network
Enter your corporate DNS server IP
address.
Leave field blank. Click Next.
Select Yes
Initial Setup
17