Mitel 3300 Technician's Handbook page 25

Tip: If you are replacing an existing 3300 ICP controller with an MXe Server
and you want to use the same system IP address for the MXe Server, initially
you will only be able to connect to the MXe Server from the local subnet.
Before you can connect to the MXe Server from other subnets, you must
manually clear the router ARP cache or wait until the router ARP cache is
automatically updated. Refer to the latest 3300 ICP Release Notes for
instructions.
Tip: The MXe Server is shipped with two hard drives, one with the software
loaded and one blank. Before continuing, mirror the blank drive starting at
Step 11 of the procedure described in "Replace One Hard Drive in an MXe
II/MXe Server" on page 210.
The MXe Server is shipped with default IP addresses assigned. The
defaults are shown in Table 1.
Table 1: Default IP Addresses for the MXe Server
ESM Name
Virtual subnet
System IP Address
Reserved IP Address
Virtual broadcast
APC IP Address
Media Gateway IP Address
E2T Card IP Address
Layer 2 (L2) Switch IP Address
Before You Begin
To complete this procedure, you will require
 Laptop
 Communications application (for example, Hyperterminal)
 RS-232 serial cable
 Ethernet cable (straight-through)
 MCD Software Installer tool
 Application Record Identification Number (AMC ARID)
Default IP Address/ Subnet Mask
192.168.1.4/30
192.168.1.5/30
192.168.1.6/30
192.168.1.7/30
192.168.1.8/24
192.168.1.2/24
192.168.1.3/24
192.168.1.1/24
Initial Setup
15