Mitel 3300 Technician's Handbook page 84

3300 ICP Technician's Handbook
Tip: You must use the latest release of the IMAT software. Refer to Table 17
on page 138 for information on the correct database version for the 3300
software load you are using.
Program an IP Address into the NSU
You must change the IP and gateway addresses to match an available
address on the LAN.
Tip: If you have an MXe Server on the same network, you must change
the NSU IP address because it will conflict with the default address of the
MIPS IP on the MXe Server.
To program the IP address that IMAT will access:
1. Program the PC's serial port with a baud rate of 38400.
2. Connect the IMAT PC to the NSU serial port.
3. Establish a terminal session with the NSU card.
4. Reboot the NSU.
5. Press any key during auto-boot to halt the boot process.
6. At the [MC269AA Boot]-: prompt enter C.
7. Change the boot parameters, inet on ethernet (e) :
192.168.1.1:ffffff00 and for gateway inet (g) : 192.168.1.251 default
values to the values provided to you by your LAN administrator.
8. For all other settings, press ENTER to accept the default.
74