Configuring A Dhcp Adsl Connection - Rfc 1483 - Mitel 1000 Owner's Manual

2. Select Enabled then click Next>. The following page is displayed:
3. The MAC address is made up of six pairs of characters. Each character
can be either a number between 0 and 9, or a letter between A and F. For
example, 00:20:2b:80:2f:30. Click in each box and type each character
pair of the MAC address provided by your ISP.
Click Next>. This page confirms your MAC spoofing settings. If you are
happy with these settings, click Confirm Changes. The Internet Access
page is displayed, and your MAC spoofing configuration is complete.
Configuring a DHCP ADSL connection – RFC 1483
If your ISP uses a DHCP DSL connection, your ISP may tell you to set unique
path and circuit numbers (called VPI and VCI) in order to connect your Mitel
1000 to the ISP's Internet service. In most cases, your Mitel 1000 will use
default settings, so you may not need to enter these values.
Your ISP will provide you with the VPI/VCI values necessary to
setup a DHCP DSL connection.
Note
76