Power Down the Controller
To power down the MXe Server:
1. Shut down the controller operating system before turning off the power
switch by
•
log in to the MSL shell and type "shutdown -h now"
OR
•
start the Server Manager and shut down using the Reboot or
Shutdown panel.
2. Continue with the procedure, "To power down the controller, Release
7.0 and later:" below.
To power down the controller, Release 7.0 and later:
1. In the System Administration Tool, navigate to Maintenance
Commands.
2. Enter the Shutdown command.
3. Remove power:
-
for the AX and MXe, set the power switch(es) to OFF
-
for all other controllers, remove the power cord.
To power down the controller, prior to Release 7.0:
1. Type appShutdown at the RTC shell.
2. When the controller boots up, the communication program will instruct
you to Press
countdown starts (Release 5.2 and later) or Press any key to stop
auto-boot (prior to Release 5.2).
3. Remove the power cord.
Perform a System Reset
To reset the system:
1. Log into the System Administration Tool (page 71).
2. In the Maintenance Commands form:
•
Rel 7.0 and later, enter the reset system command, or
•
Prior to Rel 7.0, enter the LOAD 1 command.
<SPACE><SPACE><SPACE>
to stop auto-boot AFTER
Maintenance
129