Configure Embedded Analog Boards - Mitel 3300 Technician's Handbook

13. Select 3300 Expanded Analog and click Save.
14. Configure the board. See "Configure Embedded Analog Boards" on
page 183.

Configure Embedded Analog Boards

To configure controllers with embedded analog boards:
1. Complete telephony cabling for embedded analog (see Table 26 on
page 251).
2. Complete the Music on Hold and Paging cabling if required (see
Table 27 and Table 26 on page 251).
3. Connect power to the controller. The controller detects the Analog
Main Board and Analog Option Board and the software downloads.
CAUTION: Rebooting the controller before the embedded
analog software is downloaded can render the analog
boards inoperable.
Tip: Verify, in the System Administration Tool, that 3300 Embedded Analog
or 3300 Expanded Analog appears as the Installed Type in the Analog
Services Units form.
4. Using the System Administration Tool, program the analog settings on
the controller. Refer to the System Administration Tool Online Help for
instructions.
Tip: The ONS circuits provide positive disconnect for support of applications
such as door phones.
Tip: Use the LSMeasure Tool to determine the line settings for LS trunks on
an Analog Board, Universal ASU, or ASU II (refer to the System
Administration Tool online help).
Install and Replace Units
183