Ring Gear Shim Thickness Selection; Rear Suspension And Final Drive Specifications - Yamaha V star 1100 Owner's Manual

346

Ring Gear Shim Thickness Selection

Calculate the ring gear shim thickness using the
following formula:
Ring gear shim thickness = (C + D) – [(35.40 + or
- E/100) + F].
C = the number on the final gearcase (B, Figure 41).
D = the number on the bearing housing (C, Fig-
ure 41).
E = the number on the ring gear (Figure 43).
F = the bearing thickness constant 13.00.
For example: If the final gearcase number (B,
Figure 41) is 45.51, the bearing housing number
(C) is 3.35, and the ring gear number (Figure 43) is
-05, then the pinion gear shim thickness:
= (45.51 + 3.35) + [(35.40 - 05/100) + 13]
= (45.51) + (3.35) – [(35.40-0.05) + 13]
= (48.86) – (35.35 + 13)
= 48.86 – 48.35
= 0.51
Table 1 REAR SUSPENSION AND FINAL DRIVE SPECIFICATIONS
Item
Final drive oil
Viscosity
Grade
Capacity
Shock absorber travel
Shock spring free length
Shock spring installed length
Spring rate (K1)
Stroke (K1)
Swing arm free play
End
Gear lash
Ring gear thrust clearance
43
Number
Since ring gear shims are only available in incre-
ments of tenths of a millimeter, round off the hun-
dredths digit according to the chart in Figure 42.
In the above example, round the 0.51 mm thick-
ness down to 0.50 mm. Refer to the chart in Figure
33 for available ring gear shims and select the ring
gear shim that is 0.50 mm thick.
Specification
SAE 80 hypoid gear oil
API GL-4
200 cc (6.8 U.S. oz. [7.0 Imp. oz.])
113 mm (4.45 in.)
179.5 mm (7.07 in.)
163 mm (6.42 in.)
117.7 N•m (672 lb./in. [12 kg/mm])
0-50 mm (0.00-1.97 in.)
–
0.1-0.2 mm (0.004-0.008 in.)
0.2 mm (0.008 in.)
CHAPTER TWELVE
- 05
Service limit
–
–
–
–
–
–
–
0.0 mm
–
–