ENGINE TOP END
5
6
7
8
9
10
mark. Take a photograph or make a
drawing so you can correctly time the
camshaft during assembly.
8A. When servicing the rear cylinder, set it to top
dead center on the compression stroke as follows:
a. Use the flywheel nut to turn the crankshaft
clockwise until the T-mark on the flywheel
(A, Figure 9) aligns with the cutout in the al-
ternator cover (B).
b. Make sure the timing mark on the rear cam
sprocket (A, Figure 10) aligns with the
pointer on the rear cylinder head (B).
8B. When servicing the front cylinder, set it to
TDC on the compression stroke as follows:
a. Set the rear cylinder to TDC by rotating the
engine clockwise until the T-mark (A, Figure
91
4