Yamaha V star 1100 Owner's Manual page 215

216
39
40
4. If the carburetors were not separated, disconnect
the carburetor heater wires by performing Steps 1-4
in Separation in this section.
5. Remove the top cover as follows:
a. Remove the top cover screws (A, Figure 41).
b. When servicing the rear carburetor, remove
the choke cable bracket (B, Figure 41) from
the top cover.
c. Watch for the collar (Figure 42) beneath the
outboard screw on the rear carburetor.
d. Remove the top cover (C, Figure 41) from
the carburetor.
6. Remove the spring (A, Figure 43) and vacuum
piston (B).
7. Remove and discard the small O-ring (A, Figure
44).
8. Remove the needle retainer (Figure 45) from the
vacuum piston and remove the jet needle (Figure
46).
9. Remove pilot air jet No. 2 (B, Figure 44) from
the vacuum piston bore.
10. Remove pilot air jet No. 1 (Figure 47) from the
carburetor intake horn.
41
42
43
44
CHAPTER EIGHT