204
1
8. Raise the fuel tank bracket and support the tank.
Pull the meter connector (B, Figure 5) from be-
neath the ignitor panel and disconnect the 14-pin
meter connector (A, Figure 6) from its harness
mate.
9. On California models, disconnect the EVAP
hose (B, Figure 6) from the fitting on the fuel tank.
10. If necessary, release any cable holder that se-
cures a hose or wire to the motorcycle. Note the lo-
cation of these cable holders.
FUEL TANK AND SEATS
1. Fuel tank
6. Seat bracket bolt
2. Fuel hose
7. Passenger seat
3. Fuel tank bolt
8. Nut
4. Rider's seat
9. Meter connector
5. Seat bracket
2
CHAPTER EIGHT