Starter Removal/Installation; Starter Disassembly - Yamaha V star 1100 Owner's Manual

ELECTRICAL SYSTEM
18
1. Case bolt
2. Rear end cap
3. Brush holder
4. Positive brush set
5. Nut
6. Washer/shim set
7. Spacer
8. Terminal post
9. Shim set
Removal/Installation
1. Securely support the motorcycle on a level sur-
face.
2. Make sure the main switch is off.
3. Disconnect the electrical lead from the negative
battery terminal (A, Figure 1).
4. Pull back the rubber boot and disconnect the ca-
ble from the starter terminal (A, Figure 16).
5. Remove the two starter mounting bolts (B, Fig-
ure 16). Pull the starter toward the right and remove
it.
6. Remove and discard the O-ring (A, Figure 17).
7. Installation is the reverse of removal. Note the
following:
STARTER
10. Armature
11. O-ring
12 Armature housing
(negative brush set) 13. Washer
14 Gear plate
15. Planetary gear
16. Front end cap
17. Snap ring
18. Starter gear
a. Install a new O-ring (A, Figure 17). Lubri-
b. Tighten the starter mounting bolts (B, Figure
c. Make sure the electrical connector is free of
Disassembly
Refer to Figure 18.
1. If still installed, remove and discard the O-ring
(A, Figure 17) from the front cover.
2. Remove the outer snap ring (B, Figure 17), the
starter gear (C) and the inner snap ring.
3. Remove the case bolts (Figure 19) from the
starter.
cate the O-ring with lithium soap grease.
16) to 10 N•m (89 in.-lb.).
corrosion and is tight.
249
9