Rfc Support - Foundry Networks Switch and Router Installation And Configuration Manual

Foundry Switch and Router Installation and Configuration Guide

RFC Support

The following table lists the RFCs supported by Foundry devices.
NOTE: Some devices support only a subset of the RFCs. For example, Layer 2 Switches and the ServerIron do
not support router-specific RFCs.
RFC Number Protocol or Standard
768 User Datagram Protocol (UDP)
783 Trivial File Transfer Protocol (TFTP)
791 Internet Protocol (IP)
792 Internet Control Message Protocol (ICMP)
793 Transmission Control Protocol (TCP)
826 Ethernet Address Resolution Protocol (ARP)
854, 855, and Telnet
857
894 IP over Ethernet frames
903 Reverse ARP (RARP)
906 Bootstrap loading using TFTP
919 Broadcast Internet datagrams
920 Domain requirements
922 Broadcast Internet datagrams in the presence of subnets
950 Internet standard subnetting procedure
951 Bootstrap Protocol (BootP)
1027 Proxy ARP
1042 IP datagrams over IEEE 802 networks (for Ethernet)
1058 Route Information Protocol (RIP) version 1
1075 IP Multicast
1112 Internet Gateway Management Protocol (IGMP)
1122 and Requirements for Internet hosts (routers)
1123
1141 Incremental updating of the Internet checksum
1155 Structure and Identification of Management Information (SMI)
1157 Simple Network Management Protocol (SNMP) version 1
1212 Concise MIB Definitions
1213 MIB II Definitions
E - 2
Table E.1: Foundry RFC Support
December 2000