Forward And Reverse Anti-Arcing Limit Switch - Club Car Gasoline Service Manual

3. Slide the center dash panel up the steering column by snapping out the top and then rotating the panel
out and up. There is sufficient slack in the wiring to allow for this.
4. Disconnect the wires from the key switch. Do not allow the wires to touch.
5. Remove the key switch from the dash:
• On vehicles manufactured prior to December 19, 1994 (serial numbers lower than 9522-436452), hold
the key switch and use the switch tool (Club Car Part No. 1012801) to turn the switch retaining nut on
the outside of the dash panel.
• On vehicles manufactured on December 19, 1994 and later (serial numbers 9522-436452 and greater),
from the back of the dash panel, push down on the retaining tabs surrounding the key switch and
remove the key switch cap (8) (Figure 19-11). Hold the key switch and use a 1 inch deep well socket to
remove the switch retaining nut from the outside of the dash panel.
Installing the Key Switch
1. Position the key switch in the center dash and install the switch retaining nut. If you have the later
model key switch, press the plastic cap into place on the outside of the center dash (Figure 19-11).
2. Connect the wires to the key switch terminals (See Figure 19-2, Page 19-3), and then coat the termi-
nals with Battery Protector Spray (Club Car Part No. 1014305).
3. Install the center dash into the vehicle by reversing the removal procedure. Make sure that the key
switch terminals cannot touch the frame and that the panel is properly seated and snapped into
place.
NOTE
• BENDING THE TOP RIGHT CORNER OF THE CENTER DASH INWARD WHILE INSTALLING IT
WILL PREVENT THE CONTACTS ON THE REAR OF THE KEY SWITCH FROM TOUCHING THE
METAL FRAME AROUND THE DASH.

FORWARD AND REVERSE ANTI-ARCING LIMIT SWITCH

DANGER
• DISCONNECT THE BATTERIES AS SHOWN ON PAGE 19-2, TURN THE KEY SWITCH TO THE
OFF POSITION, AND PUT THE FORWARD AND REVERSE SWITCH IN THE NEUTRAL POSI-
TION, OR THE VEHICLE WILL ENGAGE IN FORWARD OR REVERSE AND RUN OVER YOU,
CAUSING SEVERE PERSONAL INJURY OR DEATH.
WARNING
• FOLLOW ALL PROCEDURES EXACTLY AS INSTRUCTED.
• SEE THE SAFETY WARNINGS ON PAGE 19-1.
• WHEN MAKING ELECTRICAL TESTS OR REPAIRS, ALWAYS:
- WEAR SAFETY GLASSES OR APPROVED EYE PROTECTION.
- REMOVE THE KEY.
- PUT THE FORWARD AND REVERSE SWITCH IN NEUTRAL.
- DISCONNECT THE BATTERIES AS SHOWN (FIGURE 19-1, PAGE 19-2).
.
19B
E
Page 19-19