Club Car Gasoline Service Manual page 425

BATTERY
BANK
+
-
+
-
5
6
JUMPER WIRE
BATTERY
BANK
JUMPER WIRE
+
-
+
-
5
6
FIGURE 21-35
Test Procedure 14 - Reverse Buzzer Circuit
1. Turn the key switch to OFF, place the forward and reverse switch into the neutral position. Disconnect
the Z plug from the controller and disconnect the battery wires, negative wire first (Figure 21-2, Page
21-3).
2. Remove the center dash (See Removing the Reverse Buzzer, Page 20-30).
3. Secure the center dash to the vehicle so that the terminals on the key switch will not touch the cowl or
aluminum frame of the vehicle in next couple of steps.
4. Disconnect the 18-gauge red wire from the positive (+) terminal of the reverse buzzer and disconnect
the 18-gauge orange wire from the negative (-) terminal of the reverse buzzer.
5. Connect a 18-gauge jumper wire to the positive (+) terminal the reverse buzzer and connect the other
end of the jumper wire to the positive post on battery number 1.
6. Connect a 18-gauge jumper wire to the negative (-) terminal the reverse buzzer and connect the other
end of the jumper wire to the negative post on battery number 6 (Figure 21-35). The buzzer should
sound. If it does not, replace the buzzer. If the buzzer does sound, proceed to step 7.
+
-
+
-
2
1
+
-
+
-
3
4
BULLET
CONNECTOR
FIGURE 21-34
+
-
+
-
2
1
+
-
+
-
3
4
Z12
B-
BLACK WIRE
DATA HOLD
FORWARD AND
AC/DC 500V MAX
250V MAX
REVERSE SWITCH
AC V
DC V
OFF
FIGURE 21-36
CLICK
B-
Page 21-33
21A
E