ELECTRICAL COMPONENTS: IQ PLUS
ELECTRIC VEHICLES
FORWARD/REVERSE ROCKER SWITCH
See General Warnings on page 1-1.
TESTING THE FORWARD/REVERSE ROCKER SWITCH
See Test Procedure 8 – Forward/Reverse Rocker Switch on page 12-23.
FORWARD/REVERSE ROCKER SWITCH REMOVAL
1.
Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles,
Section 1, Page 1-4.
2.
Remove the instrument panel. See Instrument Panel Removal, Section 4, Page 4-10.
3.
Disconnect the 18-gauge brown, orange, and red/green wires from the rocker switch.
4.
Press the locking tabs on each end of switch and push switch out of instrument panel.
FORWARD/REVERSE ROCKER SWITCH INSTALLATION
1.
Press the locking tabs on each end of the rocker switch and push switch into instrument panel.
2.
Connect the 18-gauge brown, orange, and red/green wires to the rocker switch exactly as shown in the wiring
diagram. See Wiring Diagrams, Section 12, Page 12-4.
3.
Install instrument panel. See Instrument Panel Installation on page 4-10.
4.
Connect the batteries. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
5.
Place the Tow/Run switch in the RUN position.
6.
Inspect the vehicle for proper operation. See following WARNINGS.
WARNING
• Make sure that the vehicle operates in the forward direction when the Forward/Reverse switch is
in the FORWARD position.
• Make sure that the vehicle operates in the reverse direction when the Forward/Reverse switch is in the
REVERSE position. The reverse buzzer will sound as a warning when the Forward/Reverse switch
is in REVERSE.
• Make sure that the vehicle does not operate when the Forward/Reverse switch is in the NEUTRAL
position.
TOW/RUN SWITCH
See General Warnings on page 1-1.
TESTING THE TOW/RUN SWITCH
2016 Carryall 500 and 700 Maintenance and Service Manual
Forward/Reverse Rocker Switch
13
Page 13-3