Club Car Gasoline Service Manual page 292

Disassembly of the Transmission, Continued:
17
G
52
REMOVE FIVE
RETAINING BOLTS
AND DISCARD GASKET
3. Remove four retaining bolts (52) from the cover of the transmission. Make sure the mounting screw
(35) from the reverse side is removed and remove the cover (Figure 17-10).
WARNING
• DO NOT USE A SCREWDRIVER TO PRY THE COVER OFF THE TRANSMISSION. THIS WILL
DAMAGE THE GASKET SURFACE.
NOTE
• IF THE TRANSMISSION COVER STICKS, TAP LIGHTLY WITH A PLASTIC HAMMER ON ALTER-
NATE SIDES NEAR THE DOWEL PINS.
4. Remove gasket and discard. Clean the gasket surfaces of both the housing and the cover (Figure 17-
10).
5. Remove the input shaft thrust washer (61) and the input shaft reverse gear (62) (Figure 17-11).
6. Remove the main cluster and the shifter arm sub-assembly (Figure 17-12).
52
REMOVE
MAIN
CLUSTER
Page 17-6
GASKET
RETAIN
DOWEL PINS
FIGURE 17-10
SHIFT ARM
SUB-ASSEMBLY
FIGURE 17-12
35
62
FIGURE 17-11