Table of Contents
Advertisement
ELECTRICAL COMPONENTS: GASOLINE
VEHICLES
REVERSE BUZZER LIMIT SWITCH
REVERSE BUZZER LIMIT SWITCH REMOVAL
1.
Disconnect the battery and spark plug wire.
2.
Remove the instrument panel.
3.
Cut the wire tie that retains the limit switch leads to the instrument panel harness.
4.
Remove the nuts (1) and washers (2) (Figure 19-40, Page 19-33).
000999-005
Figure 19-40 Reverse Buzzer Limit Switch
5.
Disconnect the neutral lockout limit switch (3).
6.
Remove the neutral lockout limit switch.
7.
Disconnect the wires from the reverse buzzer limit switch (4).
8.
Remove the screws (5) and reverse buzzer limit switch.
REVERSE BUZZER LIMIT SWITCH INSTALLATION
1.
Install the reverse buzzer switch (4) with two screws (5) (Figure 19-40, Page 19-33).
2.
Install the neutral lockout limit switch (3).
3.
Install the washers (2) and nuts (1). Tighten the nuts to 5 in·lb (0.6 N·m). See following CAUTION.
CAUTION
• Do not overtighten the retaining nuts. If the nuts are over tightened, limit switches could be damaged.
4.
Connect the wires to the reverse buzzer limit switch.
5.
Connect the neutral lockout limit switch.
6.
Set the Forward/Neutral/Reverse control (FNR) to R. Make sure that both switches actuate.
2019 Carryall 500 and 700 Maintenance and Service Manual
Reverse Buzzer Limit Switch
19
Page 19-33
Advertisement
Table of Contents
Troubleshooting
